Grandstream Networks GXW40XX Uživatelský manuál stáhnout pdf (Strana 31)

Grandstream Networks, Inc. GXW40XX User Manual Page 31 of 38

Firmware 1.0.4.2 Last Updated: 06/2011

Use NAT IP

NAT IP address used in SIP/SDP message. Default is blank.

Distinctive Ringtone

Custom Ring Tone 1 to 3 with associate Caller ID: when selected, if Caller ID is

configured, then the device will ONLY uses this ring tone when the incoming call is from

the Caller ID. System Ring Tone is used for all other calls. When selected but no Caller

ID is configured, the selected ring tone will be used for all incoming calls. Distinctive ring

tones can be configured not only for matching whole number, but also for matching

prefixes. In this case symbol * (star) will be used.

If server supports Alert-Info header and standard ring tone set (Bellcore) or distinctive

ring tone 1-10 is specified, then the ring tone in the Alert-Info header from server will be

used.

For example:

If configured as *6

17, Ring Tone 1 will be used in case of call arrived from

Massachusetts. Any other incoming call will ring using cadence defined in parameter

System Ring Cadence located under Advanced Settings Configuration page.

Disable Call Waiting

Default is No. If set to YES Call Waiting indication information will not be provided to

analog phone connected to this FXS port.

Disable Call Waiting

Caller ID

Default is No. If set to YES Call Waiting caller ID will not be provided to analog phone

connected to this FXS port.

Disable Call Waiting

Tone

Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting call

arrives. The CWCID will still be displayed.

Disable Reminder

Ring for On-Hold Call

Default is No. This is to disable the Reminder Ring that is played when a call is waiting

on hold and the analog phone goes on-hook.

Disable Visual MWI

Visual message indicator is a special on-hook caller ID type message that enables and

disables the message waiting light on certain phones. GXW40XX has thi

s feature

enabled by default. However, certain phones (rare) that do not support it

may mistakenly

treat this CID signal as an incoming call. A configuration option is needed to turn on MWI

in this case.

Visual MWI Type

This is the type of signal sent to the analog phone to make it turn the lamp ON upon

receiving a Voice mail. Check the phone’s manual to find out what signal is supported,

FSK (default) or Neon.

Note: This is only supported in model GXW4024 ver 4.A or newer.

Ring Timeout

Incoming call will stop ringing when not picked up given a specific period of time.

Hunting Group Ring

Timeout

Default is 20 seconds. If call is not answered within this designated time period, the call

will be forwarded to the next member of a Hunt Group.

Delayed Call Forward

Wait Timeout

Default value is 20 seconds. In case this feature activated using * codes (*92 code), the

call will be forwarded after this preconfigured amount of time.

No Key Entry Timeout

Default is 4 seconds. Call will be completed within this time interval if no additional key

entry occurs.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Komentáře k této Příručce

Žádné komentáře

Grandstream Networks GXW40XX Uživatelský manuál Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače Grandstream Networks GXW40XX